Siemens FS720 - Loading Automatically Created Configuration to the PC; Adapting Configuration

Detailed commissioning steps
Loading automatically created configuratio
n to the PC
15
77 |
178
Building Technologies
A6V10210416_j_en_
--
Fire Safety
2018
-
08
-
29
15.5 Loading automatically created configuration to the
PC
The description in this chapter only applies if a configuration has not yet been
loaded to the 'Station' and if the ↑ BDV was installed at the 'Station' after the
'Station' was started for the first time.
1. Select the 'File' > 'New site' menu item.
a The 'Create new site' window opens.
2. Select the 'Upload from station(s)' option field.
3. Click on 'Next'.
a The 'Create site by uploading from station(s)' and 'Connect' windows open.
4. In the 'Connect' window, select 'Local connection' and then click on 'OK'.
a The configuration is loaded to 'Cerberus-Engineering-Tool'.
a The progress is displayed in the 'Create site by uploading from station(s)'
window.
a The 'Site properties' window is opened after loading.
5. Change the entries if required and click on 'OK'.
a The 'New site confirmation' window opens.
6. Click on 'Yes'.
a The 'Site' is opened in Cerberus-Engineering-Tool.
15.6 Adapting configuration
Adapt the configuration of the ↑ Site' in Cerberus-Engineering-Tool, e.g.:
● Changing customer texts
● Setting the properties and the ↑ parameter sets
● Changing the assignment of ↑ 'Zones' and ↑ 'Sections'
● Configuring controls
● Configuring the operating and display units
● Configuring the network
You will find information about configuring a '
Site
' in document
A6V10210424
.
See chapter 'Applicable documents'.
See also
2 Applicable documents [➙ 11]