Siemens FS720 - Radio Gateway FDCW221

Updating the firmware
Updating the FW of the peripheral devices
22
138 | 178
Building Technologies
A6V10210416_j_en_
--
Fire Safety
2018
-
08
-
29
Manually setting device to update mode
Proceed as follows if you are prompted to manually set the device to update mode
in step 3:
1. Set the DIP switch S200-1 to 'ON'.
a The device is set to update mode.
2. Follow the instructions in the dialog in the Engineering Tool.
3. Set the DIP switch S200-1 to 'OFF'.
4. Follow the additional instructions in the dialog in the Engineering Tool.
FT2001-
A1
Printed circuit board view
22.8.5 Radio gateway FDCW221
You must update the firmware of the ↑ radio gateway FDCW241 with a SWING
tool and the MCL-USB adapter FDUZ227. You will find information on this in
document A6V10227639. See chapter 'Applicable documents'.
See also
2 Applicable documents [➙ 11]
S200
1
1
1
1
1
1
12
ON