Commissioning a control panel with integrated extinguishing
Preparing the control panel with integrated exting
uishing for commissioning
14
71 |
Building Technologies
14.1 Preparing the control panel with integrated
extinguishing for commissioning
1. Connect the cables for the extinguishing components, ↑ detector lines, and the
peripheral devices.
2. Connect the power supply (mains and batteries).
a The fire control panel starts and reads in the internal hardware.
a During start-up, the 'FAULT' LED flashes and the display shows the
progress.
a During start-up, the firmware version F-FXS7211 is displayed.
3. Wait until the display indicates the selection of the ↑ BDV.
a The fire control panel is prepared for commissioning.
It is not necessary to install the BDV for the further procedure. This saves having
to restart the 'Station'.
Following preparation, you can for instance perform the following steps, depending
on the selected commissioning variant:
● Load the configuration from the PC to the fire control panel.
To Next Page
Loading...
