Changing and expanding the FDnet/C
Replacing stationary devices of the same type
12
48 | 178
12.1.2 Configure a new device
1. Extend the configuration in Cerberus-Engineering-Tool, e.g., in the ↑ 'Detection
tree'.
2. Allocate the read-in devices to the elements of the detection tree or the control
tree in Cerberus-Engineering-Tool.
3. If required, configure additional 'Controls' (also for several 'Stations') using the
layout plan or finalize available 'Controls'.
12.2 Replacing stationary devices of the same type
NOTICE
between detector/detector zone and customer text
Inaccurate messages in the event of an alarm
● You must not change the C-NET topology at the same time as adding extra
devices.
● After extending or changing a ↑ 'Site' always run a test to check the
assignment between detector/detector zone and customer text.
You will find additional information about the individual steps on the specified
pages.
1. Switch the C-NET detector line off. Link [➙ 79]
2. Replace the C-NET device with a device of the same type. Several devices can
be replaced.
3. Rectify localization errors. Link [➙ 86]
4. Connect the PC to the ↑ 'Station'. Link [➙ 27]
5. Load the configuration from the 'Station' to the PC. Link [➙ 32]
6. Test the function of the ↑ 'Site'. Link [➙ 86]
7. Remedy any errors you notice and load the corrected configuration from the
PC to the 'Station'. Link [➙ 30]
8. Disconnect the PC from the 'Station'. Link [➙ 27]
You will find information about installing and uninstalling in the documentation for
the corresponding 'C-NET' device.
Refer to document A6V10227639 for information on how to replace radio
detectors. See chapter 'Applicable documents'.
See also
2 Applicable documents [➙ 11]
To Next Page
Loading...
