Siemens FS720 - Connecting a Sub-Stub to a Loop

Changing and expanding the FDnet/C
-
NET detector li
ne
Connecting a sub
-
stub to a loop
12
57 |
178
Building Technologies
A6V10210416_j_en_
--
Fire Safety
2018
-
08
-
29
12.7 Connecting a sub-stub to a loop
You will find additional information about the individual steps on the specified
pages.
1. Switch the C-NET detector line off. Link [➙ 79]
2. Physically connect the sub-stub to the ↑ loop. You will find more information
about this in document A6V10210390. See chapter 'Applicable documents'.
3. Read-in the C-NET devices. Link [➙ 82]
4. Connect the PC to the ↑ 'Station'. Link [➙ 27]
5. Load the configuration from the 'Station' to the PC. Link [➙ 32]
6. Test the function of the ↑ 'Site'. Link [➙ 86]
7. Remedy any errors you notice and load the corrected configuration from the
PC to the 'Station'. Link [➙ 30]
8. Disconnect the PC from the 'Station'. Link [➙ 27]
See also
2 Applicable documents [➙ 11]