4 | 178
6 A - Commissioning standalone 'Station' without PC .................................38
6.1 Configuring the power supply ..................................................................... 39
6.2 Entering customer texts using the Person Machine Interface...................... 39
6.3 Setting detector parameter sets ................................................................. 40
7 B1 - Commissioning standalone 'Station' with PC, without pre-configuration ..
.........................................................................................................41
8 B2 - Commissioning standalone 'Station' with PC, with pre-configuration ...42
9 C- Commissioning networked 'Stations' .................................................43
10 Adding a 'Station' to an existing 'Site' .....................................................44
11 Merging two 'Sites' ..............................................................................45
11.1 Adding 'Site' B to 'Site' A ............................................................................ 46
11.2 Connecting 'Sites' physically to one another ............................................... 46
12 Changing and expanding the FDnet/C-NET detector line .........................47
12.1 Extending the detector line to include additional devices ............................ 47
12.1.1 Mount and wire new devices ....................................................... 47
12.1.2 Configure a new device ............................................................... 48
12.2 Replacing stationary devices of the same type ........................................... 48
12.3 Permanently removing stationary devices .................................................. 49
12.4 Removing or replacing non-stationary devices ........................................... 49
12.4.1 Base with loop contact ................................................................ 49
12.4.2 Base without loop contact ........................................................... 51
12.4.3 Temporarily removing multiple non-stationary devices ................. 54
12.4.4 Permanently removing non-stationary devices ............................ 54
12.5 Replacing 'Manual call point' of the same type ........................................... 55
12.5.1 Switching on the replace mode ................................................... 55
12.5.2 Switching off replace mode ......................................................... 56
12.5.3 Testing 'Manual call point' ........................................................... 56
12.6 Convert two stubs into a loop ..................................................................... 56
12.7 Connecting a sub-stub to a loop ................................................................. 57
13 Calibrating an FDnet/C-NET detector line ..............................................58
13.1 Automatic line calibration ........................................................................... 59
13.2 Manual line calibration ............................................................................... 60
13.3 Calibration report ....................................................................................... 61
13.4 Troubleshooting ......................................................................................... 66
14 Commissioning a control panel with integrated extinguishing ....................70
14.1 Preparing the control panel with integrated extinguishing for commissioning .
.................................................................................................................. 71
14.2 Calibrating monitored outputs .................................................................... 72
14.3 CE marking ............................................................................................... 73
To Next Page
Loading...
