Siemens FS720 - Page 63

Calibrating an FDnet/C
-
NET detector line
Calibration report
13
63 |
178
Building Technologies
A6V10210416_j_en_
--
Fire Safety
2018
-
08
-
29
Entries in the calibration report
Entry in the calibration
report
Possible content* Description
Header: Line 1/2/1
ReportCalibration 2018-04-24 10:11:12
Information on the line created for the
calibration report.
1. Calibration status Line 1/2/1 UNCALIBRATED
Loop 1_1/1_2
The entry indicates the calibration
status for the line. The calibration may
have the following status:
● Uncalibrated: There is no data on a
previously completed calibration
process for a line in the system.
Line 1/2/1 CALIBRATED - PASS
Loop 1_1/1_2
● Calibrated: There is data on a
previously completed calibration
process for a line in the system. The
entry also shows whether the
calibration was successful.
Line 1/2/1 CALIBRATED - FAIL
Loop 1_1/1_2
Line 123 / 121 / 4 RE - CALIBRATION
Loop 1_1/1_2
● Recalibration required: During
active operation, this indicates
whether the line needs to be
recalibrated. The data from the last
calibration is no longer valid as the
line topology and/or configuration
parameters have been changed in a
way that affects the power
consumption of the line.
2. Time since last
calibration
Date/time: 2018-04-20 11:12:13
Line 1/2/1 PASS
The entry shows the last time the line
was calibrated and whether the
calibration process was successful.
3. Power consumption of
the line card
FDnet line card
Module 1/2 PASS Itot = 499 mA
The entry shows the entire power
consumption of the line card in an alarm
scenario. The following results are
possible:
● Pass: The power consumption of
the line is below the maximum load
capacity of the line card of 0.5 A.
FDnet line card
Module 1/2 FAIL Itot = 580 mA
● Fail: The power consumption of the
line is above the maximum load
capacity of the line card of 0.5 A.
FDnet line card
Module 1/2 UNKNOWN Itot = 420 mA
● Unknown: The entire power
consumption of the line card is
unknown as either some of the lines
on the card have not been
calibrated or line calibration for
certain lines has been deactivated.
The displayed power consumption
is the sum of all calibrated lines on
the line card.