PID Control
9.4 PID Setup and Tuning
BW500 and BW500/L
116 Operating Instructions, 12/2016, A5E33482052-AD
8. Again observe the oscillation of the control output. Compare results to the figures 4,5 and 6
below.
9. The
D
term is not critical in typical shearing type weigh feeder applications. The purpose of
the
D
term is to anticipate where the process is heading by looking at thetime, rate, and
direction of change of the process variable. The
D
term becomes very useful in applications
where the material control point is far away from the measuring point. An example of this
would be a weigh belt or conveyor with a belt scale (constant speed) being fed from a pre-
feeder some distance or more than a few seconds process time from the scale.
A properly set
D
term will make the initial oscillations around the setpoint smaller, as in figure
6. A D term set too high induces high oscillations, as in figure 4. Omission of the
D
term, or
set too low, shows no effect on the system.
10.The above closed loop cycling procedure allows ease in start up, but final adjustments may
be necessary in actual process operation.
To Next Page
Loading...
