Siemens Milltronics BW500/L - Page 197

Troubleshooting
13.2 Specifically
BW500 and BW500/L
Operating Instructions, 12/2016, A5E33482052-AD
195
Error Code
! a)
Code Name
Message/Action
240 Integrator not config-
ured
P002-P017 must be
programmed
241 ✓ No PID mA Input PID Process Value
Source (P402) or PID
Setpoint (P414) has
been programmed for a
mA Input, however mA
Input Function (P255)
has not been pro-
grammed properly.
242 ✓ No PID mA Output PID System (P400) has
been turned on, but mA
Output (P201) has not
been programmed
properly.
243 No batch setpoint relay Batch has been set up,
but no relay has been
configured for a set-
point.
244 ✓ No speed relay Second speed sensor
configured, but no relay
is assigned
PF Power Failure Displayed at the bottom
right corner of the dis-
play if power is inter-
rupted after the
integrator has been
calibrated.
a)
The codes in this column with checkmarks will produce relay output for a diagnostic alarm.