Siemens SIMODRIVE 611 universal - Page 922

E
E-922
 Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
Output terminals
Assignment, for the optional TERMINAL
module (from SW 4.1), 6-527
for control board, 6-498
for the optional TERMINAL module,
6-526
Freely parameterizable, 6-498, 6-526
Inverting, 6-499, 6-527
Permanently–connected, 6-498
Overcontrol protection, 6-543
Override, 6-370
Overview
of the input signals, 6-476
of the output signals, 6-501
P
Parameter list, A-732
Parameter set changeover, 6-576
Parameterizing, 1-26, 3-88
Overview when, 3-88
Using SimoCom U, 3-96
Using the display and operator unit, 3-89
via PROFIBUS, 5-287
Parameterizing a direct measuring system,
A-889
Parameterizing indirect measuring systems,
A-889
Parameters
for diagnostics, 4-134
Function–initiating, 4-131
Motor data set–dependent, 6-581
Parameter set–dependent, 6-576
with . (bit number), vii
with : (sub–parameters), vii
with :64 (traversing block–dependent),
vii, 6-411
with :8 (parameter set–dependent), vii,
6-576
Parking axis, 6-483
Passive referencing (from SW 5.1), 6-452
Password protection (from SW 8.1), 3-99
PE spindle, 4-153
Permanent–magnet spindle, 4-153
Personnel – qualified?, xi
Pin assignment
for encoder connection (X411, X412),
2-82
for the optional PROFIBUS-DP module
(X423), 2-84
of the serial interface (X471), 2-83
Pinion, 6-354
PKW area, 5-206, 5-273
Position loop gain, 6-378
Position setpoint, 6-381
E Index
04.05