Siemens SIMOTION D410 Commissioning Manual

5.16.4 Restoring the default settings of SINAMICS Integrated
Prerequisite
You must be online to SINAMICS Integrated in order to restore its default settings.
Restoring the default settings
1. Right-click "SINAMICS_Integrated" in the Project Navigator.
2. Select the "Target device > Restore default settings" command from the shortcut menu.
This restores the delivery state of SINAMICS Integrated.
5.16.5 Restoring the default settings of SIMOTION D410
Overview
SIMOTION D410 is supplied with default parameters such as the transmission rate or
PROFIBUS addresses. You can restore the default settings using the DIL switch. This deletes
the following data:
● Non-volatile SIMOTION data in the SIMOTION device
● The backup copy of non-volatile SIMOTION data on the CompactFlash Card
(PMEMORY.XML/PMEMORY.BAK)
● User data in the "volatile SIMOTION data" area and on the CompactFlash Card
● The communication configuration (IP and DP parameters) on the CompactFlash Card is
set to the factory settings.
All licenses on the CompactFlash Card are retained.
Commissioning (software)
5.16 Deleting data
SIMOTION D410
156 Commissioning Manual, 04/2014

Siemens SIMOTION D410 Specifications

General

Brand	Siemens
Model	SIMOTION D410
Category	Control Unit
Language	English