Siemens SIMOTION D410

Maintenance and service
6
6.1 Overview
Introduction
It is possible to distinguish between the following scenarios when replacing and updating
components:
●
Replacing modules (spare part scenario)
– Spare parts replacement for SIMOTION D410 (Page 167)
– Removing and replacing the SIMOTION D410 (Page 168)
– Replacing DRIVE-CLiQ components (Page 170)
– Replacing the fan (Page 172)
– Replacing the CompactFlash card (Page 174)
● Adapting a project (new device type/device version)
The project needs to be adapted if you want to change the type (e.g. D410 DP -> D410
PN) or version of the SIMOTION device in your existing project.
– Creating backup copies (project/CF) (Page 175)
– Backing up user data (backup variables) (Page 175)
– Upgrading a user project to the new SCOUT version (Page 177)
– Platform replacement via XML export/import (Page 178)
– Preparing for a device replacement (Page 179)
– Replacing a device in HW Config (Page 180)
– Upgrading technology packages (Page 181)
– Upgrading the device version of SINAMICS S120 control units (Page 184)
– Upgrade the libraries (Page 185)
– Save project, compile and check consistency (Page 185)
● Performing a firmware and project update
– Upgrading the CompactFlash Card's bootloader (Page 186)
– Update - preparatory measures (Page 186)
– Update via SIMOTION IT web server (Page 187)
– Upgrade via device update tool (upgrading SIMOTION devices) (Page 188)
– Update via CompactFlash Card (Page 190) with the steps:
Backup of the CF card data (Page 190)
Update via CF card (Page 191)
SIMOTION D410
Commissioning Manual, 04/2014 163