Siemens SIMOTION D410 Commissioning Manual

7. Check
the position of the fan cables to ensure that they do not become jammed when the
plastic enclosure is replaced.
8. Replace the plastic enclosure and re-engage all 7 snap hooks.
6.2.5 Replacing the CompactFlash card
If spare parts are being used, you must seek the assistance of the Technical Support Center
in order to convert the license key code of the defective CompactFlash Card to that of the new
CompactFlash Card.
Proceed as follows to write your project to the new CompactFlash Card:
● Replacing the CompactFlash Card (Page 194)
● Writing to a CompactFlash Card (Page 195)
Detailed information about licensing can be found:
● In the SIMOTION SCOUT Configuration Manual
● as well as In the FAQ (
http://support.automation.siemens.com/WW/view/en/36947932)
6.3
Adapting a project (Upgrading the project / Replacing the SIMOTION
controller)
6.3.1 Overview
Overview
The project needs to be adapted if you want to replace the type (e.g. D410 DP with D410 PN)
or version of the SIMOTION device in your existing project.
Procedure
The exact procedure for project adaptations depends on the scope of the target hardware and
version changes.
An overview of the various applications can be found in Service and maintenance in section
Overview (Page 163).
Maintenance and service
6.3 Adapting a project (Upgrading the project / Replacing the SIMOTION controller)
SIMOTION D410
174 Commissioning Manual, 04/2014

Siemens SIMOTION D410 Specifications

General

Brand	Siemens
Model	SIMOTION D410
Category	Control Unit
Language	English