Preface
Contents of the commissioning manual
This manual is part of the SIMOTION D documentation package.
Scope
The SIMOTION D410 commissioning manual describes commissioning the
SIMOTION D410 DP and SIMOTION D410 PN Control Units.
A separate
SIMOTION D410‑2
Commissioning and Hardware Installation Manual is available
for the SIMOTION D410‑2 DP and D410‑2 DP/PN Control Units.
The software configuration is described in this manual based on SIMOTION SCOUT and
SIMATIC STEP 7 Version V5.x.
The Engineering Framework Totally Integrated Automation Portal (SCOUT in the TIA Portal)
only supports the newer SIMOTION D4xx‑2 Control Units. Configuration of the SIMOTION
D4xx Control Units in the TIA Portal is not possible.
Information in this manual
The following information blocks describe the purpose and use of the commissioning manual.
● Description
This section provides information pertaining to the SIMOTION system and its integration
into the information landscape.
● Commissioning (hardware)
This section describes how to start up the device and what you must take into account.
● Configuring SIMOTION D410
This section describes how to integrate SIMOTION D410 in a project and how to configure
the interfaces.
● Commissioning (software)
This section describes how to configure a plant and how to test the drives and axes you
configured.
● Service and maintenance
This section describes how to replace a module, how to run updates, and how to modify
settings.
● Service and diagnostics
This section provides information about service and diagnostics options, as well as LED
states.
● Appendices with factual information for reference (for example, Standards and Approvals,
and ESD)
● Index for locating information.
SIMOTION D410
Commissioning Manual, 04/2014 3
To Next Page
Loading...
Need help?
General
