6.3.10 Upgrade the libraries
Depending
on the configured properties of the libraries used in the project (device-dependent
or device-independent), an upgrade of the libraries may be required if the SIMOTION device
or the device version changes.
1. Open the LIBRARIES directory in the project navigator.
2. Select a library, right-click to open the context menu, and select "Properties...."
3. Select the "TPs/TOs" tab in the "Properties" window.
4. Select the SIMOTION device and the technology packages for which the library is to be
valid.
5. Close the dialog box with "OK".
Note
Please
also observe the notes on device-dependencies in the SIMOTION SCOUT online
help.
6.3.11 Save project, compile and check consistency
Procedure
1.
Execute "Save and recompile all" ("Project" > "Save and recompile all" menu).
2. Then perform a consistency check ("Project" > "Check consistency" menu).
3. If error messages occur, correct these and repeat the operation.
Note
Note the difference between
●
"Save and recompile all" and
● "Save and compile changes"
Save and recompile all
All sources of the entire project are recompiled with this command.
The
command is suitable if you are quite sure that all the old data from older SCOUT versions
should be removed and replaced with new compilation results.
Use this command if you specifically want to convert a project from an earlier SCOUT version
to a newer version. In this way, you take over all error corrections and optimizations.
Maintenance and service
6.3 Adapting a project (Upgrading the project / Replacing the SIMOTION controller)
SIMOTION D410
Commissioning Manual, 04/2014 185
To Next Page
Loading...
Need help?
General
