3. For verification purposes, perform the measurement again.
4.
With the modified parameters, the controller displays a much better transient response. If
necessary, you can continue changing the value until the transient response has reached
its optimum level.
Figure 5-40 Measurement with modified P-gain
5.15
Downloading and saving SIMOTION user data
Overview
It is advisable to backup all SIMOTION user data (programs, configuration data, parameters)
to the CF card after having completed commissioning of SIMOTION D410.
Loading user data
Use the "Target system" > "Load" > "Load to target system" command to transfer the following
data from the SIMOTION SCOUT engineering system (ES) to the "non-volatile data" area of
SIMOTION D410:
● Configuration data
● Programs
● Parameterization
● Technology packages
Commissioning (software)
5.15 Downloading and saving SIMOTION user data
SIMOTION D410
150 Commissioning Manual, 04/2014
To Next Page
Loading...
