Siemens SIMOTION D410 - Page 38

The CF card must be inserted when you start up SIMOTION D410 in order to load the
SIMOTION Kernel.
NOTICE
Damage to the CompactFlash card from electrical fields or electrostatic discharge
The CompactFlash card is an ESD-sensitive component.
De-energize the SIMOTION D410 device before inserting or removing the CompactFlash
card. The SIMOTION D410 is in a de-energized state when all the LEDs are OFF.
Comply with the ESD rules.
Procedure
To insert the CF card, perform the following steps:
1.
The direction of insertion of the CF card is indicated by an arrow located on both the plug-
in slot and the CF card. Align the CF card with the arrows.
2. Gently push the CF card into the card slot of SIMOTION D410 until it engages. The properly
inserted card does not protrude from the SIMOTION D410 housing.
$UURZV
&RPSDFW)ODVK&DUG
6ORWIRU&RPSDFW)ODVK&DUG
Figure 3-1 Inserting the CF card
Commissioning (hardware)
3.2 Inserting the Compact Flash card
SIMOTION D410
38 Commissioning Manual, 04/2014