SINAMICS S110/S120 Control Unit, and selected Terminal Modules can be interconnected
symbolically.
Table 5-1
Control units that support a symbolic assignment
Module Supports symbolic assignment
SIMOTION D
● SIMOTION D410-2
● SIMOTION D410
● SIMOTION D4x5‑2
● SIMOTION D4x5
● As of SIMOTION V4.3
● As of SIMOTION V4.2
● As of SIMOTION V4.2
● As of SIMOTION V4.2
Controller extension
●
CX32-2
● CX32
As of SIMOTION V4.2
SINAMICS S110 CU305 As of SINAMICS V4.3
SINAMICS S120
●
CU310-2
● CU310
● CU320‑2
● CU320
● As of SINAMICS V4.4
● As of SINAMICS V2.6.2
● As of SINAMICS V4.3
● As of SINAMICS V2.6.2
See also
Only the drive configuration by means of symbolic assignment is described in this
documentation.
The
documentation of older SIMOTION versions can be found on the Internet at the following
Internet address (
http://support.automation.siemens.com/WW/view/en/40211807) .
For further information on the configuration of the TO axis and TO externalEncoder, see the
TO Axis Electrical/Hydraulic, External Encoder
Function Manual.
Commissioning (software)
5.1 Overview of commissioning
SIMOTION D410
78 Commissioning Manual, 04/2014
To Next Page
Loading...
Need help?
General
