Siemens SIMOTION D410 Commissioning Manual

6. Select a motor holding brake (if installed).
Figure 5-6 Selecting a motor holding brake
7.
If you are using a motor that is not equipped with a DRIVE‑CLiQ interface, select the
encoder order number in the "Encoder Selection via Motor Order Number" dialog box.
Figure 5-7 Selecting a motor encoder (1)
Commissioning (software)
5.2 Configuring the system in offline mode
SIMOTION D410
86 Commissioning Manual, 04/2014

Siemens SIMOTION D410 Specifications

General

Brand	Siemens
Model	SIMOTION D410
Category	Control Unit
Language	English