5.9 Inserting DCC blocks
Before you copy the "SwayControl" DCC chart, update the DCC block library. Open a DCC
chart of your choice, e.g. "SwayControl", in the application project. Under the "Options" menu
item, select "Block types...".
Figure 5-21 Updating block types
Click "OK" in the popup that then appears.
Figure 5-22 Popup for updating the DCC library
The window that now opens shows the available libraries on the left-hand side with the
previously imported libraries shown on the right-hand side. Only import the most recently
available library. Do this by clicking the right arrow key.
Configuration
5.9 Inserting DCC blocks
SC integrated STS, GSU
Operating Instructions, 07/2019, A5E48271265B AA 127
To Next Page
Loading...