Siemens SIMOTION D4x5-2 DP/PN

Connections
The input block is connected with the output of the DCC_SCCAMERA DCC block using a unit-
global variable. The output signal is transferred to the camera measuring system via Ethernet.
Table 3-36 FB_Send_Preparation connections
Name Type Data
type
"Camera" unit-global variables Meaning
iDistanz IN DINT camera_SC_Hoist_Height_PLC Transfer external hoist position
from the PLC
aSendData OUT ARRAY
[0..7] OF
BYTE
SendData The data sent to the camera
measuring system
3.3.2.19 FB_ReadWrite_MV440
Symbol (FBD representation)
)%B5HDG:ULWHB09
%<7(
$55$<
LBDEXVHU
LBE6WDWXV
TBDEXVHU
TBE&WUO
TBE2.
TBZ(UURU
TBGL;
TBGL<
TBGL5RW
TBGL'LVW
TBGL;BY
$55$<
%<7(
%22/
:25'
',17
',17
',17
',17
',17
TBGL<BY
TBGL5RWBY
TBGL'LVWBY
TB&RXQWHU
',17
',17
',17
',17
,17
',17
LBGL7LPH2XW
LBGL([W'LVW
Figure 3-33 FB_ReadWrite_MV440
Task
The block prepares the send and receive addresses for the camera measuring system.
This block is used if PROFINET has been selected as the camera communication system.
Overview of the software
3.3 Sway control function blocks
SC integrated STS, GSU
Operating Instructions, 07/2019, A5E48271265B AA 81