7.2.4.2 V1: Move to internally stored trim, list and skew positions
When "TLS positioning" mode is selected, the landside or waterside positions are approached
depending on the position of the trolley.
WOVBSRV
VNHZBWDUJHWBH[W
6NHZ$QJOHBH[WBIRUB7/6
PRYH
,1
DBLQ
,1
,1
,1
287
%63(('B%B1250
%63(('B$B1250
287
287
EBRXW
FBLQ
GBRXW
PRWLRQBWHUPLQDWHG
%63(('B&B1250
%63(('B'B1250
287
287
287
287
287
287
Figure 7-11 Signal sequence for moving to internally stored position in "TLS positioning" mode
Section 1:
Select the "TLS positioning" mode by setting the "tls_pos" control bit (STW1_PLC_TLS, bit 7).
Section 2:
Activate the move command by setting the "move" control bit (STW1_PLC_TLS, bit 5).
TLS control function description
7.2 TLS modes and TLS functions
SC integrated STS, GSU
252 Operating Instructions, 07/2019, A5E48271265B AA
To Next Page
Loading...