Siemens Sinumerik 840D Series - Page 153

10.03
4.13 Monitoring functions
4-153
 Siemens AG, 2003. All rights reserved
SINUMERIK 840D/SIMODRIVE 611 digital, HLA Module (FBHLA) - 10.03 Edition
5613 ALARM_REACTION_RESET Cross reference: -
Config. shutdown response to RESET alarms
Bit 0= 0: No enable signal cancellation in response to
configuration errors
1: Enable signal cancellation in response to
configuration errors
Related to:
HLA
Protection level:
3/3
Unit:
HEX
Default:
0
Minimum:
0
Maximum:
FFFF
Data type:
UNS.WORD
Active:
Immediately
5732 CL1_RES_IMAGE Cross reference: -
Image ZK1_RES register Related to:
HLA
Protection level:
3/3
Unit:
HEX
Default:
0
Minimum:
0
Maximum:
FFFF
Data type:
UNS.WORD
Active:
Immediately
With MD 5601: ALARM_MASK_RESET can be set to conceal Reset alarms. If
the relevant bit is set to 0, the corresponding error monitoring function is active.
If the bit=1, the relevant error message is suppressed. The default setting is
active for all monitoring functions.
With MD 5613: ALARM_REACTION_RESET is set to configure changeover of
the relevant Reset alarm.
Alarm messages, see Chapter 6, numbers 300600...300699.
5609 ENC_SPEED_LIMIT Cross reference: -
Max. measuring velocity of linear scale Related to:
HLA
Protection level:
3/3
Unit:
mm/min
Default:
240 000.0
Minimum:
1.0
Maximum:
240 000.0
Data type:
FLOAT
Active:
Immediately
The limit frequency of the measured-value conditioning hardware is monitored
with respect to A/B signals. The limit frequency is calculated from machine data
MD 5005 and MD 5609. It is approximately 100 kHz and is normally specified
by the measuring system manufacturer.
Maximum measuring velocity (MD 5609) / increments (MD 5005) = encoder limit
frequency
Example: 120 000 mm/min / 20
µm = 100 kHz
5605 SPEEDCTRL_LIMIT_TIME Cross reference: -
Time for velocity controller at limit Related to:
HLA
Protection level:
3/3
Unit:
ms
Default:
200.0
Minimum:
20.0
Maximum:
1000.0
Data type:
FLOAT
Active:
Immediately
“Limit frequency
reached”
measuring circuit
Velocity controller
at limit
4 Firmware Drive Functions
02.99