Siemens Sinumerik 840D Series Function Manual

10.03
2.2 Integration in SINUMERIK 840D/SIMODRIVE 611 digital
2-28
 Siemens AG, 2003. All rights reserved
SINUMERIK 840D/SIMODRIVE 611 digital, HLA Module (FBHLA) - 10.03 Edition
M600
P600
X351
X111
X121
X141
X161
X171
X172
X181
U1 V1 W1 X131 PE
Red
Yellow
Red
5 V voltage level
fault
Device ready
(DC link
precharged)
DC link
overvoltage
Electronics power
supply faulty
Device is not ready,
no enable signal
(term. 63, 64 or 48)
Line fault
Power supply
Device bus
DC link
connection
Red
Green
Red
LED displays
5.3
5.2
5.1
63
9
9
64
19
74
73.1
73.2
72
7
45
44
10
15
15
R
9
112
48
111
113
NS2
NS1
AS2
AS1
Relay contact,
Ready to operate
message
NC
contact
NO
contact
Relay contact for group message
I
2
t and motor overtemperature
Power disable
Enabling voltage
Drive enable
Reference potential for enable voltage
Enabling voltage
P24
P15
N15
N24
M
M
RESET (R+term.15)
Enabling voltage
Setup mode
Contactor energization, start
213
Signaling contact,
line contactor
Enabling signal for internal line contactor
Signaling contact for starting lockout (NC contact)
M500
P500
2U1
1U1
2V1
1V1
2W1
1W1
DC link power supply for bridging line failures
Electronics power supply from external source
Electronics power supply from external source
Electronics power supply from external source
1)
1)
1) Jumpers inserted in delivery state
LED displays
1)
Fig. 2-5 Interfaces on mains supply module (OI and I/RF module)
2 Configuration
02.99

Siemens Sinumerik 840D Series Specifications

General

Axes	Up to 31 axes
Power Supply	24 V DC
Control Type	CNC
Interface	Ethernet, PROFIBUS
Display	TFT color display
PLC	Integrated PLC (programmable logic controller)
Operating Temperature	0°C to 45°C
Relative Humidity	Up to 95% (non-condensing)
Max. Number of Channels	Up to 10 channels