Siemens Sinumerik 840D Series Function Manual

SINUMERIK

Documentation
Revision history
Brief details of this edition and previous editions are listed below.
The status of each edition is indicated by the code in the “Remarks” column.
Status code in the “Remarks” column:
A New documentation. . . . . .
B Unmodified reprint with new order number . . . . .
C Revised version with new edition status. . . . . .
If the technical subject matter shown on the page has changed compared to the
previous edition status, this is indicated by the changed edition status in the header
of the respective page.
Edition Order no. Remarks
02/99 6SN1197-0AB60-0BP0 A
08/99 6SN1197-0AB60-0BP1 C
04/00 6SN1197-0AB60-0BP2 C
10/03 6SN1197-0AB60-0BP3 C
This manual is supplied as part of the CD-ROM documentation (DOCONCD)
Edition Order no. Remarks
03/04 6FC5 298-7CA00-0BG3 C
Trademarks
SIMATICr, SIMATIC HMIr, SIMATIC NETr, SIROTECr, SINUMERIKr, SIMODRIVEr and
MOTION-CONNECTr are registered trademarks of Siemens AG. Other names in this publication might be
trademarks whose use by a third party for his own purposes may violate the rights of the registered holder.
More information is available on the Internet at:
http://www.siemens.com/motioncontrol
This document was created with Interleaf V 7
The reproduction, transmission or use of this document or its
contents is not permitted without express written authority. Offenders
will be liable for damages. All rights, including rights created by patent
grant or registration or a utility model or design, are reserved.

Siemens AG, 1999-2004. All rights reserved
Other functions not described in this documentation might be
executable in the control. This does not, however, represent an
obligation to supply such functions with a new control or when
servicing.
We have checked that the contents of this document correspond to
the hardware and software described. Nevertheless, differences
might exist and therefore we cannot guarantee that they are
completely identical. The information given in this publication is
reviewed at regular intervals and any corrections that might be
necessary are made in subsequent editions. We welcome all
recommendations and suggestions.
Subject to change without prior notice
Siemens Aktiengesellschaft.
O
rder no. 6SN1197-0AB60-0BP3
Printed in Germany
3ls

Siemens Sinumerik 840D Series Specifications

General

Axes	Up to 31 axes
Power Supply	24 V DC
Control Type	CNC
Interface	Ethernet, PROFIBUS
Display	TFT color display
PLC	Integrated PLC (programmable logic controller)
Operating Temperature	0°C to 45°C
Relative Humidity	Up to 95% (non-condensing)
Max. Number of Channels	Up to 10 channels