Siemens SIPROTEC 7SJ62 - Resetting and Setting the Statistics

Operators Tools
7-137SJ62 Manual
C53000-G1140-C121-1
From the
Device Front
With a device ready for operation, first press the key. The 0$,10(18 appears.
The first menu item $QQXQFLDWLRQ is marked.
Press the key to enter the $1181&,$7,21 sub-menu (see Figure 7-1).
Use the key to select the item 6WDWLVWLF, and switch to the list of statistics values
using the key. The 67$7,67,& list appears. See figure 7-15.
Figure 7-15 Statistics Viewed from the Front Display
From PC with
DIGSI
®
4
Under Annunciation (Figure 7-2), the statistics can be found by double clicking. Dou-
ble click on 6WDWLVWLF. The sub-menus 6WDWLVWLF and 6HW3RLQWV6WDWLV
WLF appear in the data window. By double clicking on one of the two alternatives, the
associated contents are displayed in another window. See Figure 7-16.
Figure 7-16 DIGSI
®
4 List of Statistic Values
7.1.2.2 Resetting and Setting the Statistics
The statistics are secured against a loss of power supply voltage. The values can,
however, be set to zero, or to any desired value within the setting limits.
From the
Device Front
In the 67$7,67,& sub-menu, select the value to be set by using the key, and then
press the key. See Figure 7-17 for an example of changing the operating hours
counter. After a password is entered, the cursor blinks and the number value is high-
lighted in a box. The number can be overwritten using the number keys. If the new val-
ue is outside of the allowable range, either above or below, then the maximum or min-
imum limit value appears at the bottom edge of the display. Confirm the change with
the key.
MENU
67$7,67,&6

Σ ,D N$
Σ ,E N$
Etc.
:
ENTER
ENTER
www . ElectricalPartManuals . com