Appendix
A-30 7SJ62 Manual
C53000-G1140-C121-1
A.6 Information List
NOTE:
The following table lists all data which are available in the maximum complement of the device. Dependent on the ordered model, only those data
may be present which are valid for the individual version.
The symbol ’ > ’ indicates that the source of the indication is a binary input.
O/O – ON / OFF DP – Double Point Indication
OUT – Output Indication C – Command without Feedback
SP – Single Point Indication CF – Command with Feedback
IntSP – Internal Single Point Indication MV – Measured Value
SP_Ev – Spontaneous Event LV – Limit Value
F# Description Type of
Informa-
tion
Log-Buffers Configurable in Matrix SCADA Interface
General IEC 60870-5-103
Event Log
Trip Log
Sens. E Log
Marked in Oscill.
Record
LED
Binary Input
Function Key
Binary Output
Event Log
Trip Log
Sens. E Log
Chatter Blocking
Status ON / OFF
General Interrogation
Type
Information-No.
Data Unit (ASDU)
General Interrogation
3 >Synchronize Internal Real Time Clock
(>Time Synch)
SCBPFG
IM_EvO
M
LED BI REL O/O GI 135 48 1 GI
5 >Reset LED (>Reset LED) SP LED BI REL O/O GI 135 50 1 GI
>Back Light on (>Light on) SP O/O LED BI REL OM FM O/O GI
www . ElectricalPartManuals . com
To Next Page
Loading...
