Initial Inspections
3-2 7SJ62 Manual
C53000-G1140-C121-1
3.1 Unpacking and Packing
The 7SJ62 is packaged at the factory to meet the requirements of IEC 60255–21.
Unpacking and packing must be done with normal care, without using force, and with
appropriate tools. Visually check the device immediately upon arrival for correct me-
chanical condition.
Please observe also the brief reference booklet and all notes and hints that are en-
closed in the packaging.
The shipping packaging can be reused in the same manner for further shipment. Stor-
age packaging alone, for individual devices, is not sufficient for shipping. If other pack-
aging is used, shock requirements under IEC 60255–21–1 Class 2 and IEC 60255–
21–2 Class 1 must be met.
The device should be in the final operating area for a minimum of two hours before the
power source is first applied. This time allows the device to attain temperature equilib-
rium, and dampness and condensation to be avoided.
www . ElectricalPartManuals . com
To Next Page
Loading...
Need help?
General