Siemens SIPROTEC 7SJ62 Instruction Manual

Operators Tools
7-197SJ62 Manual
C53000-G1140-C121-1
Use the key to select the measured value group that has the values desired, and
switch to the display of this group with the key. Figure 7-22 shows an example for
the display of operating measured values.
Figure 7-22 Viewing Operating Measured Values on the Front Display
Move up and down in the table of measured value groups using the and keys.
Use the key to return to the 0($685(0(17 sub-menu. Use the key to return to
the 0$,10(18.
From PC with
DIGSI
®
4
The measured value groups are found under Measurement (Figure 7-2) with a double
click, as shown in Figure 7-23, left.
Figure 7-23 Measurement Window in DIGSI
®
4
The measured values are divided into the following groups:
1. 3ULPDU\ Measured values, primary.
The measured values are converted from secondary to pri-
mary according to the settings entered for the current and
voltage transformers and the nominal device quantities.
If the device is equipped with a sensitive ground fault detec-
tor, then the real (I
Nsw
) and reactive (I
Nsb
) portions of the
ground current can also be seen in a sub-group.
2. 6HFRQGDU\ Measured values, secondary
The operating measured values for the measurement quan-
tities present directly at the device terminals.
If the device is equipped with a sensitive ground fault detec-
tor, then the real (I
Nsw
) and reactive (I
Nsb
) portions of the
(residual) ground current can also be seen in a sub-group.
0($685(0(17

!2SHUDWLRQSUL
!2SHUDWLRQVHF
23(5$7,2135,

!,D $
!,E $
Etc.
Etc.
MENU
:
www . ElectricalPartManuals . com

Siemens SIPROTEC 7SJ62 Specifications

General

Brand	Siemens
Model	SIPROTEC 7SJ62
Category	Relays
Language	English