Siemens SIPROTEC 7SJ62 Instruction Manual

Initial Inspections
3-77SJ62 Manual
C53000-G1140-C121-1
the display will be unreadable and that no operation will be possible using the integrat-
ed operator control panel. Therefore, the preset contrast value should only be
changed in small steps (1 or 2 levels).
q When the device is ready for operation, first press the key. The 0$,10(18 ap-
pears.
q Using the key, select the menu item 6HWWLQJV, and switch to the settings using
the key. The 6(77,1*6 menu appears.
q Using the key, select the menu item 6HWXS([WUDV and switch to the selection
6(783(;75$6 using the key. See Figure 3-3.
q Using the key, select the menu item &RQWUDVW.
q If a change of the contrast of the integrated LCD is desired, press the key. The
existing setting appears in a frame with a blinking cursor.
q Overwrite the present setting with the desired setting using the numerical keys. The
setting range is [11 to 22].
q Confirm the change with the key, or cancel the change with the key.
Exit the menu using the key, or return to the main menu using the key.
Figure 3-3 Operating Sub-menu for Adjusting the Display Contrast
MENU
ENTER
ENTER ESC
ESC MENU
ENTER 6(783(;

0/)%9HQ²!
&RQWUDVW²!

6(783(;75$6

'DWH7LPH²!
&ORFN6HWXS²!
6HULDO3RUWV²!
'HYLFH,'²!
0/)%9HUVLRQ²!
!&RQWUDVW²!
www . ElectricalPartManuals . com

Siemens SIPROTEC 7SJ62 Specifications

General

Brand	Siemens
Model	SIPROTEC 7SJ62
Category	Relays
Language	English