Configuration in STEP 7
5.6 Configuring networks and network nodes in STEP 7 / NetPro
TIM DNP3
108 System Manual, 06/2014, C79000-G8976-C253-03
● Number of stations in sub-cycle:
This parameter cannot be configured for DNP3 and has no significance.
● Transmission mode:
This parameter cannot be configured for DNP3 and has no significance.
This tab contains special parameters required only when using dial-up networks.
Figure 5-19 Properties - DNP3 Dial-up Network TIM dialog, Dial-up Network tab
The dial-up network parameters include:
To Next Page
Loading...
