Siemens TIM 4R-IE DNP3 - The Modbuswrite Object

The SINAUT Configuration Tool
6.6 TD7onTIM
TIM DNP3
226 System Manual, 06/2014, C79000-G8976-C253-03
Name:
S7 CPU status output byte
Memory area:
T
he following options are available:
•
DB: Data block
•
Memory bit: Memory bit area
•
Output: Process output image (PIQ)
DB No.:
Specifies the DB number in the CPU if the data block memory area (DB) was
selected
Address
[byte]:
Input box for the byte number in
the selected memory area
Name:
MODBUS slaves
Explanation:
In the 8 input boxes, the MODBUS slaves to be monitored are assigned to
the 8 status bits of the output byte. The MODBUS address is specified for
each MODBUS slave.
Bit status:
Status = 0: Prob
lem on partner or bit not assigned
Status = 1: Partner OK
ModbusGateway
The "ModbusGateway" system object is used to activate the MODBUS protocol for a serial
interface of the TIM and to configure the connection to the MODBUS slaves.
"Gateway property" box
Name:
Connection to TIM interface
Explanation:
Specifying the serial interface of the TIM
Selection for TIM
4R-IE DNP3:
•
WAN 1 = interface X1
•
WAN 2 = interface X2
Name:
MODBUS role
Explanation:
Specifies the MODBUS role for the TIM.
Only the default role "Master" is possible.
"WAN connection" box
Name:
Interface type:
Explanation:
Selection of the interface standard and the directional dependency of the
interface