Siemens TIM 4R-IE DNP3 - Setting the Time; SINAUT Diagnostics; TIM Diagnostics

Diagnostics and upkeep
7.3 SINAUT diagnostics and service tool
TIM DNP3
254 System Manual, 06/2014, C79000-G8976-C253-03
Performance Data tab
The Performance Data tab does not contain any diagnostic information relevant to TIM
modules. For CPU modules, information is displayed on organization blocks (OB), system
blocks (SFC, SFB) and address ranges.
Communication tab
The Communication tab displays the following information:
● Maximum and unused connection resources for
– PG communication
– OP communication
– S7 basic communication
● Configured cycle load due to communication. For a TIM, this is 100%.
Information on a communication relates only to the CPU.
IP Parameter tab
The IP Parameters tab displays the most important IP parameters of an Ethernet TIM:
● IP address: Configured IP address of the module.
● Subnet mask: Configured subnet mask of the module.
● Default router: If a default router was specified during configuration, the IP address of the
default router is displayed here.
● IP settings: Indicates where the module obtained the IP parameters from.
Note
With a TIM
4R-IE
DNP3, only information on the first Ethernet port P1 is displayed. For an
overview of the status and parameters of both Ethernet ports
of the module, refer to
SINAUT Diagnostics,
IP Parameters tab.