The SINAUT Configuration Tool
6.9 Downloading
TIM DNP3
System Manual, 06/2014, C79000-G8976-C253-03
239
Action in the SINAUT
configuration tool
Necessary follow-up action
Network nodes Changing the parameter
settings of a network node
The SDBs of the module that contains this network node must
Networking a network node
Network nodes Deleting a network node All telecontrol connections running via this network node are
then invalid and are removed the next time you open the
connection configuration. When necessary, these must be
replaced by alternative connections. The SDBs or DBs of all
modules that were involved in these deleted connections must
be regenerated in the subscriber administration.
Network nodes Canceling the networking of a
network node
All telecontrol connections running via this network node are
then invalid and are removed the next time you open the
connection configuration. When necessary, these must be
replaced by alternative connections. The SDBs or DBs of all
modules that were involved in these deleted connections must
be regenerated in the subscriber administration.
Telecontrol connection Adding a telecontrol
connection
The SDBs or DBs of all subscribers over which this connection
runs must be regenerated in the subscriber administration.
Telecontrol connection Deleting a telecontrol
connection
The SDBs or DBs of all subscribers over which the deleted
connection runs must be regenerated in the subscriber
Telecontrol subscriber Changing the parameter
settings of a subscriber
The SDBs or DBs of all connections that run over this
subscriber must be regenerated in the subscriber
Destination subscriber
properties of TD7onTIM
Changing the parameter
settings of the destination
subscriber properties of a
destination subscriber of
The SDBs of all TIMs with TD7onTIM that communicate with
this destination subscriber must be regenerated in subscriber
administration.
To Next Page
Loading...
