Uses and properties of the TIM
1.12 Requirements for operation - necessary components and services
TIM DNP3
36 System Manual, 06/2014, C79000-G8976-C253-03
Software versions
Required software
This manual applies to the following configuration software versions:
●
SINAUT engineering software
Required version: V5.4
Order number: 6NH7997-0CA54-0AA0
An already installed full version V5.0 / V5.1 / V5.2 / V5.3 can upgraded to version 5.4 with
an upgrade package. You will find the upgrade package under the following article
number: 6NH7997-0CA54-0GA0
Information on the upgrade package can be found on the Internet pages of Siemens
Industry Online Support under the following entry ID:
87795994 (http://support.automation.siemens.com/WW/view/en/87795994)
You will find the STEP 7 version required for the SINAUT engineering software in the
"STEP 7" bulleted point below.
The version of the SINAUT engineering software described here is supported by the
following operating systems:
– Windows XP Professional SP2
– Windows Server 2003 SP2
With STEP 7 V5.5 SP1, the following operating systems are also supported:
– Windows 7 (32-bit or 64-bit)
The Windows XP mode in Windows 7 is not released.
– Windows Server 2008 (32-bit), without or with SP1
– Windows Server 2008 R2 (64-bit), without or with SP1
There is no guarantee that STEP 7 will run on other operating systems; any attempt to do
so is the responsibility of the user. Refer to the readme of the relevant STEP 7 version for
further details.
●
At least STEP 7 V5.4 Service Pack 4 is required.
●
The devices described in this manual are compatible with the following process control
system versions:
– SIMATIC PCS 7 V7.1 SP2 (basic system for the DNP3 master station)
– SIMATIC PCS 7 TeleControl Server V7.1 SP2 (add-on for telecontrol functions)
To Next Page
Loading...
