Siemens TIM 4R-IE DNP3 - Configuring Td7 Ontim (Overview)

The SINAUT Configuration Tool
6.6 TD7onTIM
TIM DNP3
166 System Manual, 06/2014, C79000-G8976-C253-03
6.6.2.4
DNP3 object groups: Implementation in objects of TD7onTIM
Object groups supported by DNP3 TIM modules
The following table provides an overview of the DNP3 object groups and variations
supported by the DNP3 TIM and the TD7onTIM objects that implement these in the two
station types "station" or "master station".
The station type "master station" can be a TIM module in a master station or a TIM 4R IE
DNP3 in a node station.
For some TD7onTIM objects, the communications partner must support certain DNP3
implementation levels. If there are special requirements, you will find the corresponding
information in the right-hand column.
Table 6- 4 Assignment of DNP3 object groups and TD7onTIM objects
Object
group
Variation
Format according
to the DNP3
specification
Station type
TD7onTIM object
S7 data
type
DNP3 level of the
partner ***
1 2 Binary input with
flag
Station
Bin04B_S, Cmd01B_S
BOOL
Master
station
Bin04B_R
2 2 Binary input event
- with absolute
time
Station
Bin04B_S
BOOL
Cmd01B_S
BYTE
Master
station
Bin04B_R BOOL
10 2 Binary output -
status with flags
Station
Bin08X_S **
BOOL
Cmd01B_R
BYTE
Master
station
Bin08X_R **
BOOL
Cmd01B_R
BYTE
11 2 Binary output
event - with time
Station
Bin08X_S **
BOOL
As of DNP3 level 4
Master
station
Bin08X_R
**
12 1 Binary command -
control relay output
block
Station Bin04B_R
Bin08X_R
BOOL
Cmd01B_R
BYTE
Master
station
Bin04B_S
Bin08X_S ****
BOOL
Cmd01B_S ****
BYTE
20 2 Counter - 16-bit
with flag
Station
Cnt01D_S, Cnt04D_S
WORD
Master
station
Cnt01D_R, Cnt04D_R
21
*
2 Frozen counter -
16-bit with flag
Station Cnt01D_S, Cnt04D_S WORD DNP3 level 1 to 4
6 Frozen counter -
16-bit with flag and
time
Cnt01D_S, Cnt04D_S WORD DNP3 level 5 only