Siemens TIM 4R-IE DNP3 - Cpus for a Standalone TIM 4 R-IE DNP3 with S7-400 or S7-400 H

Uses and properties of the TIM
1.12 Requirements for operation - necessary components and services
TIM DNP3
System Manual, 06/2014, C79000-G8976-C253-03
35
S7-400H
CPU 410-5H
6ES7 412-5HX08-0AB0
(Version 01)
CPU 412-3H
6ES7 412-3HJ14-0AB0
(Version 01)
CPU 412-5H
6ES7 412-5HK06-0AB0
(Version 01)
CPU 414-4H
6ES7 414-4HM14-0AB0
(Version 01)
CPU 417-4H
6ES7 417-4HT14-0AB0
(Version 01)
1.12.3
Software
1.12.3.1
Required software components
Software components
● Configuration software
– STEP 7 V5
STEP 7 is required for the basic configuration.
– SINAUT engineering software
The SINAUT configuration and diagnostics software from this software package is
required for the PG.
● Control center software
SIMATIC PCS 7 TeleControl from the SIMATIC environment can be used as control
center software.
You will find the required software versions in the section Software versions (Page 36).