Siemens TIM 4R-IE DNP3 - Page 151

The SINAUT Configuration Tool
6.5 The Subscriber Administration
TIM DNP3
System Manual, 06/2014, C79000-G8976-C253-03
151
6.4.3
Recovering lost connections
If changes are made to connections in a project, it is advisable to open the Recover lost
connections
window afterwards. You can do this with:
● The
SINAUT / Recover lost connections menu or
● The
Recover lost connections button on the right of the toolbar
If changes to the connection configuration, previously existing connections were modified
and either linked to other objects or completely deleted, connection configuration has
algorithms with which to find these lost connections in the project.
Deleted connections are displayed in red in the left-hand part of the
Recover lost
connections
window. Connections that are similar to the deleted connections may also be
listed in the right-hand part of the window. This allows you to check whether there is a
substitute or successor to the last connection.
If you no longer require the lost connections in the left-hand part of the window, you can
delete these by selecting and clicking the
Delete lost connections button.
If connections are displayed in the right-hand part of the window that are similar to the last
connections you can insert these again if you have accidentally deleted connections and still
require them. To do this, select the connection in the right-hand part of the window and click
the
Recover connections button.
6.5
The Subscriber Administration
6.5.1
Functions of subscriber administration
Configuring subscriber data
Once the telecontrol connections have been configured, all the requirements are met so that
you can configure the subscriber data for the DNP3 communications subscribers as follows:
● Generating subscriber data
● Displaying subscriber data
● Editing subscriber data
● Pack the subscriber data so that it can be understood by the hardware components; in
other words, in data blocks (DBs) or system data blocks (SDBs).
Processing is always necessary when data needs to be acquired that is connection-related;
in other words cannot be assigned to a particular subscriber.
Processing of subscriber data is also necessary when data other than for objects is stored,
for example the DB configuration for the CPU modules.
After starting subscriber administration, first the previously known data of the subscribers is
loaded from the data management and then updated. The following data is updated: