Siemens TIM 4R-IE DNP3 - Page 297

Diagnostics and upkeep
7.3 SINAUT diagnostics and service tool
TIM DNP3
System Manual, 06/2014, C79000-G8976-C253-03
297
Event ID
(hex)
Detailed
event
(hex)
Status message
Meaning / remark
F560
0805
Error sending a message
F560 0806 Error receiving a message or ID
unknown.
F560
0807
Unknown message type received
F560 0808 Message queue overflow (incoming) Meaning in byte 5 of the diagnostics message:
• 1 = LAN COM
• 2 = S7 adapter
• 3 = Modbus adapter
F460 0808 Message queue overflow (outgoing) Meaning in byte 5 of the diagnostics message:
• 1 = LAN COM
• 2 = S7 adapter
• 3 = Modbus adapter
F960
0809
CTS error (incoming)
F860
0809
CTS error (outgoing)
F560
080A
UART error (incoming)
F460
080A
UART error (outgoing)
F360 080B Status change of the MODBUS slave
(incoming)
MODBUS slave not accessible
F260 080B Status change of the MODBUS slave
(outgoing)
MODBUS slave accessible
F560 080C Negative S7 acknowledgement
received (message only incoming)
Byte 6 of the message codes the error class (ERRCLS)
and byte 7 codes the error code (ERRCOD). For the
meaning of ERRCLS and ERRCOD, see Meaning of
ERRCLS and ERRCOD (Page 298).
F560 080D Negative S7 access result received
(message only incoming)
Bytes 6 and 7 of the message code the access result
(hex) with the following meaning:
• FF = success
• 01 = hardware error
• 02 = temporary lack of resources
• 03 = object access not permitted
• 05 = invalid address
• 06 = type not supported
• 07 = type inconsistent
• 0A = object does not exist
• 0E...EF: Reserved
• FE = data unchanged since last access