Siemens TIM 4R-IE DNP3 - Page 32

Uses and properties of the TIM
1.12 Requirements for operation - necessary components and services
TIM DNP3
32 System Manual, 06/2014, C79000-G8976-C253-03
For communication via classic WAN, the TIM requires a suitable modem:
– DNP3 dedicated line: Dedicated line modem MD2
Optional: LTOP overvoltage protection modules for the dedicated line attachment
– Analog dial-up network Analog dial-up modem MD3
Alternative: Third-party modem with RS-232 interface and support of AT commands
and the duplex mode
– ISDN network: ISDN MD4 modem (is no longer available)
Alternative: Third-party ISDN modem with RS-232 interface and support of AT
commands and the duplex mode
– GSM network: MODEM MD720
When connecting modems, you require a suitable cable.
For more information on routers, modems, connecting cables and optional components, refer
to the section Accessories (Page 313).
1.12.2
Compatible SIMATIC CPUs
1.12.2.1
CPUs for installing the TIM 3V-IE DNP3 in an S7-300
Compatible CPU types in the S7-300
The TIM 3V-IE DNP3 can be used in an S7-300 as a communications processor (CP). In
principle, all S7-300 standard and compact CPUs can be combined with this TIM. All the
following standard and compact CPUs can be used without restrictions.
Standard CPU modules
CPU 312
ab 6ES7 312-1AE14-0AB0
CPU 314
ab 6ES7 314-1AG14-0AB0
CPU 315-2 DP
ab 6ES7 315-2AH14-0AB0
CPU 315-2 PN/DP
ab 6ES7 315-2EH14-0AB0
CPU 315T-2 DP
ab 6ES7 315-6TH13-0AB0
CPU 315F-2 DP
ab 6ES7 315-6FF04-0AB0
CPU 315F-2 PN/DP
ab 6ES7 315-2FJ14-0AB0
CPU 317-2 DP
ab 6ES7 317-2AJ10-0AB0
CPU 317-2 PN/DP
ab 6ES7 317-2EK14-0AB0
CPU 317T-2 DP
ab 6ES7 317-6TK13-0AB0
CPU 317F-2 DP
ab 6ES7 317-6FF03-0AB0
CPU 317F
-2 PN/DP
ab
6ES7 317-2FK14-0AB0
CPU 319F-3 PN/DP
ab 6ES7 318-2FL01-0AB0
CPU 319-3 PN/DP
ab 6ES7 318-3EL01-0AB0