Configuration in STEP 7
5.1 Overview
TIM DNP3
80 System Manual, 06/2014, C79000-G8976-C253-03
The SINAUT software also allows the configuration of the following objects:
● WAN networks and WAN network nodes
● TIM modules
● WAN connections
● Objects (for example system and data objects)
Sequence of configuration of a telecontrol system
The configuration of a telecontrol system is shown below step-by-step. The dialogs of the
SINAUT configuration tool are also explained.
Figure 5-2 Sequence of configuration of a telecontrol system
When configuring a telecontrol system, the SINAUT configuration tool must be started after
the network has been configured to allow configuration of the communications module,
connections and then the data of the subscribers.
To Next Page
Loading...
