Siemens VDO DTCO 1381 - Preparing Sealing Tools

Service only
Installation 5.2 Instructions on installing the DTCO 1381
Edition 07/2007 Technical Description DTCO 1381 5 - 11
TD00.1381.00 132 102
Preparing sealing tools
Assembling the sealing tool
To emboss the seal caps properly, equip and adjust the sealing pliers
accordingly.
1. Insert an original Kienzle sealing insert (1) into the pliers and
engage it using the locking screw (1a).
2. Close the pliers and screw in the knurled screw (2) to the limit
stop.
3. Screw the knurled screw (3) into the sealing insert up to the
limit stop and engage using the locking screw (3a).
Embossing the sealing cap
4. Perform an embossing test. Place the neutral sealing cap (4)
over the knurled screw and press the sealing pliers together to
the limit stop.
• The embossing of the sealing cap must be clearly readable.
5. If necessary fine-adjustment the knurled screw (2) and use the
locking screw (2a) to secure the position.
Inserting the sealing cap
6. Insert the sealing cap (5) into the respective sealing cup and
use the mounting tool (6) to press it in.
3
2
3a
1
1a
4
2a
2
5
6