Siemens VDO DTCO 1381 - Entering Parameters

Service only
Preprogramming 7.3 Performing the preprogramming
Edition 07/2007 Technical Description DTCO 1381 7 - 7
TD00.1381.00 132 102
7.3.4 Entering parameters
Legally stipulated parameters The following parameters are legally stipulated and must be pro-
grammed:
• Vehicle identification number
• Vehicle registration number
• Country of registration
• Characteristic coefficient (w-value)
• Recording equipment constant (k-value)*
• Effective wheel circumference
•Tire size
• Legally permitted maximum speed
•Odometer reading
•UTC time
•Calibration date*
* The DTCO 1381 sets this data automatically.
Device-specific parameters Depending on the variation of the DTCO 1381, other parameters
that are not legally-stipulated must be programmed:
•n-constant
•Drive shaft I/U
•etc.
Please refer to the test device instructions for information on how to
enter the calibration parameters.
The DTCO 1381 sets the calibration date and the purpose for the cal-
ibration automatically.
Via the menu functions you can print (printout vehicle "technical
data") or display (display vehicle "technical data") the calibration
date and the purpose for the calibration.