Siemens VDO DTCO 1381 - Checking the Condition of the DTCO 1381 Upon Delivery; Checking the Identification and Sealing

Service only
5.5 Performing the installation Installation
5 - 18
© Siemens VDO Automotive AG Edition 07/2007
TD00.1381.00 132 102
5.5.2 Checking the condition of the DTCO 1381 upon delivery
Checking the identification and sealing
The following points must be checked before installing the
DTCO 1381:
1. Check to make sure that the DTCO 1381 identification infor-
mation on the model plate correspond to those on the delivery
certificate:
• Manufacturer
• Device type (product number).
2. Check to make sure that the DTCO 1381 identification infor-
mation on the model plate correspond to the data electronically
saved in the DTCO 1381:
• Manufacturer
• Device type (product number)
• Serial number.
3. Check to make sure that the following seals on the DTCO 1381
are undamaged:
•Device sealing
• Seal for battery compartment.
You can read out the data stored in the DTCO 1381 via the following
interfaces:
• Calibration interface
• K-Line diagnosis interface*
• CAN bus diagnosis*
* version-dependent
Via the menu functions you can print (printout vehicle "technical
data") or display (display vehicle "technical data") the data stored in
the DTCO 1381.
Attention!
If any of the above-mentioned points do not match the specifica-
tions, do not install the DTCO 1381!