Siemens VDO DTCO 1381 - Menu Navigation after Removing Workshop Card; Removing Workshop Card

Service only
Activation 9.3 Performing the activation
Edition 07/2007 Technical Description DTCO 1381 9 - 11
TD00.1381.00 132 102
9.3.2 Removing workshop card
1. Press the ejection button of the card slot in which the
workshop card is located.
• The subsequent procedure is menu-guided.
2. After the card has been released (mechanical unlocking of the
card), remove the workshop card from the card slot.
3. Use the button or to set the respective activity, such
as "
a".
Menu navigation after removing workshop card
The DTCO 1381 automatically sets the calibration date and the
purpose of the calibration (1) when the workshop card is removed.
Via the menu functions you can print (printout vehicle "technical
data") or display (display vehicle "technical data") the calibration
date and the purpose for the calibration.
Step / menu display Explanation / meaning
1 The name of the cardholder appears; a progress bar shows that the
DTCO 1381 is transferring data to the workshop card.
2 Enter country at the end of the workday
– Select the country with the button or and
– acknowledge with the button .
Cancel entry of country
– Press the button to cancel the entry of the country.
Select region if required
– Select the region with the button or and
– acknowledge with the button .
3 Continuation of data transfer to workshop card.
4Print day value
– To print the day value, select "ZFT" with the button or , or
select "OP" and
– acknowledge with the button .
5 Continuation of data transfer to workshop card.
.VTUFSNBOO
 g
zu FOE DPVOUSZ
  áá
&
zu FOE SFHJPO
 á
"/
.VTUFSNBOO
 g
Ijo EBZ

OP
IjoáEBZ
ááááá
ZFT
.VTUFSNBOO
 d