Siemens VDO DTCO 1381 - Page 176

Service only
9.3 Performing the activation Activation
9 - 10
© Siemens VDO Automotive AG Edition 07/2007
TD00.1381.00 132 102
6 If incorrect PIN entered
– Acknowledge message with the button and re-enter the
number.
Cancel PIN entry
– Press the ejection button of the card slot in which the
workshop card is located.
– After the card has been released (mechanical unlocking of the
card), remove the workshop card from the card slot.
Attention!
If an incorrect PIN is entered five times, the workshop card will be
blocked and the process cancelled. The workshop card will be
ejected.
7 Continuation of reading the workshop card.
The standard display appears; the DTCO 1381 still remains in opera-
tional mode.
8 After the card has been read, the card symbol (1) appears and the
DTCO 1381 switches to the calibration mode (2).
9 Pairing with the KITAS 2171
The DTCO 1381 automatically starts pairing with the KITAS 2171.
Activating the DTCO 1381
After pairing with the KITAS 2171 has completed, the DTCO 1381
automatically begins the EC recording equipment activation.
10 After activation completes, the message "activation done" appears.
11 The DTCO 1381 restarts and reads the workshop card again.
The text "jDBSE" is blinking while the workshop card is read (this
mask is displayed only if the ignition is turned on).
Comment
During activation, the DTCO 1381 resets the odometer reading to the
value "0.0 km".
12 After reading the workshop card the standard display appears, the
DTCO 1381 is now in calibration mode "g".
Step / menu display Explanation / meaning
{v XSPOHáFOUSZ
uhd LNI
b  LN a
.VTUFSNBOO
 d
uhg LNI
bj LN a
21
pr

BDUJWBUJPO EPOF
u gn
aj
jDBSE a
u n
LN
YYYYYY 
 
u g LNI
aj LN a