Siemens VDO DTCO 1381 - Connection Plug a

Service only
5.5 Performing the installation Installation
5 - 30
© Siemens VDO Automotive AG Edition 07/2007
TD00.1381.00 132 102
Connection plug A
Fig. 5 - 17: Connect the DTCO 1381 connection plug A
1. Separate the vehicle’s battery from the on-board power supply.
or
Interrupt the respective power circuit by removing the fuse.
2. Then insert the white plug (1) into the connection plug "A" on
the DTCO 1381.
3. Reconnect vehicle battery.
or
Re-insert the fuses.
Caution! Danger of short circuits
Always observe the vehicle manufacturer’s instructions when exe-
cuting the following work steps!
1
blue bl
brown br
yellow ye
gray gr
green gn
light blue lbl
red rd
black blk
white wt
brown-black brblk
red-grey rdgr