Siemens VDO DTCO 1381 - Device-Specific Parameters; Other Parameters

Service only
7.3 Performing the preprogramming Preprogramming
7 - 6
© Siemens VDO Automotive AG Edition 07/2007
TD00.1381.00 132 102
7.3.2 Device-specific parameters
Additional device-specific parameters must be preprogrammed for
operation of the DTCO 1381, e.g.:
•n-constant
• Configuration
• CAN configuration
•Product key
•Drive shaft I/U
• Production data (such as dimming parameters, limit values
for n)
•etc.
7.3.3 Other parameters
Other parameters can be preprogrammed if necessary:
• Installation date
• Date of the next calibration
•etc.
The settings for the device-specific parameters are dependent on
the customer or device type.