Siemens VDO DTCO 1381 - Chapter 11 Regularly Inspection

Service only
Table of contents Regularly inspection
11 - 2
© Siemens VDO Automotive AG Edition 07/2007
TD00.1381.00 132 102
Table of contents
Chapter 11 Regularly inspection
11.1 General instructions ................................................... 11-3
11.1.1 Personnel prerequisites ..................................... 11-3
11.1.2 Technical prerequisites ...................................... 11-3
11.1.3 Handling the tachograph cards ......................... 11-4
11.1.4 Calibration instructions ..................................... 11-5
11.1.5 Legal requirements for when to
perform a calibration ........................................ 11-5
11.1.6 Access to the calibration functions .................... 11-5
11.1.7 Parameter measurements ................................. 11-6
11.1.8 Checking the KITAS 2171 and the
KITAS sensor cable ............................................ 11-7
11.1.9 Pairing with the KITAS 2171 .............................. 11-8
11.2 Instructions for the regularly inspection .................... 11-9
11.2.1 Legal requirements for when to
perform a regularly inspection .......................... 11-9
11.3 Testing equipment .................................................... 11-10
11.4 Checking the buffer battery ..................................... 11-11
11.5 Performing the regularly inspection ........................ 11-12
11.5.1 Inserting workshop card ................................. 11-13
Menu navigation after inserting
workshop card ................................................ 11-14
11.5.2 Legally stipulated parameters .......................... 11-17
11.5.3 Device-specific parameters .............................. 11-17
11.5.4 Other parameters ........................................... 11-18
11.5.5 Entering parameters ....................................... 11-18
11.5.6 Removing workshop card ................................ 11-20
Menu navigation after removing
workshop card ................................................ 11-20
11.5.7 Creating and sealing installation plate ............. 11-21