Siemens VDO DTCO 1381 - 11.4 Testing equipment

Service only
11.4 Testing equipment Regularly inspection
11 - 10
© Siemens VDO Automotive AG Edition 07/2007
TD00.1381.00 132 102
11.4 Testing equipment
The calibration is performed with a appropriate test equipment; for
example, the Siemens VDO SDS test devices MTC 1602.04 or
ATC 1601.26.
Fig. 11 - 1: Siemens VDO SDS test devices MTC 1602.04 / ATC 1601.26
For the calibration with the Siemens VDO SDS test devices the fol-
lowing testing equipment must be available:
(1) BTC test software, version DTCO 1381 or higher
(2) Mount (MTC/ATC) with firmware version DTCO 1381
(3) Programming cable
(4) Diagnosis cable DTCO 1381
DTCO 1381 testing and programming software
(without figure)
Authentication (5) Workshop card
An approved recording equipment manufacturer, vehicle man-
ufacturer, installer, or a workshop uses its card to identify itself
to the DTCO 1381, enabling saving of activities under this
identity.
After a positive authentication, the workshop card enables
activation; pairing with the KITAS 2171; calibration, and
testing of the DTCO 1381; the downloading of data; and
transfer, test, and test drives.
2
4
3
5
1